A card reader to wire into something else
This is a card reader and nothing more. It reads 125 kHz proximity cards from up to 10 cm and sends the number out as 26 or 34-bit Wiegand, in 200ms or less. Connect it to an access panel, or use it as the exit-side reader for a terminal that takes Wiegand input.
Two input lines let the controller drive its red and green LEDs, and there's a beeper.
Low draw, light body
It runs on 6 to 14V DC and draws 70mA at most, so the controller it's wired to can usually power it. The black case is 116 x 75 x 17.3 mm and weighs 50 g.



